Files (1)

ROT_-_Ford_Vent.stl

STL

132.2 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
ROT_-_Ford_Vent.stl	Primary model	132.2 KB STL	Slice file	Slice file	Slice file	Ensure proper orientation to minimize supports

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Knobs/Buttons

Ford Explorer Mix Door Lever

0 downloads37 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

I apologize that I didn't do this sooner, when I remembered exactly what vehicle I was working on at the time. EDIT: I found a pic of the vin! Info Updated I made this part to repair a 2009 Ford Explorer that wouldn't blow air out the panel vents. I opened the glove box and dropped it down so i could access behind it. I found this little piece with the arm broken clean off. It pulled straight out. Ford only offered it as part of a $400 assembly, that I would have to remove the dash to install. I changed the design to take a screw where the old one had a plastic pivot. It's not parametric but I have included the (messy) openscad file.