Ford F-150 Lid Latch for center console armrest 2010-2015 preview

Files (1)

2012_F-150_Armrest_Latch_Narrow_reinforced_pins.stl

STL

28.4 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 75%	100% solid	Recommendation
2012_F-150_Armrest_Latch_Narrow_reinforced_pins.stl	Primary model	28.4 KB STL	Slice file	Slice file	Slice file	Print with the pins and latch flat on the build plate to minimize supports

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Ford F-150 Lid Latch for center console armrest 2010-2015

0 downloads14 views0 quality score

Print this part

Check the available model and saved setup details before opening your slicer.

Files

1 hosted model file

STL

Material

PETG or ASA for durability in a car environment

Print time

Slice to calculate

Filament

Slice to calculate

Supports

supports likely, verify in slicer

Infill

75% infill for strength, with thicker walls for the latch and pins

Difficulty

Not rated — inspect geometry

Vehicle heat

Cabin/interior use; avoid high-heat zones

Open the STL, 3MF, or OBJ model in your slicer before printing. Confirm orientation, supports, print time, filament use, and printer compatibility. Test-fit before installing it in a vehicle.

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

I broke my original latch on my 2012 F-150. I remixed this and made the pins braces a little narrower to make it easier to put in i also removed the 3d printed spring part and reinforced the pins instead this was still a very tight fit you might need to still sand the pins down shorter. might modify more if it breaks in future. A paper clip spring will work but If you have original spring, use that instead. attached is a youtube of how to install the latch i do not own this video. Print Settings Printer: Turnigy Fabrikator Rafts: Yes Supports: Yes Resolution:.2m Infill: 75% Notes: slice the print so the pins and latch are flat on the glass with supports touching build plate Post-Printing ============= print laying flat like this and make sure you have supports touching build plate lot of overhang in the latch part Category: Automotive.