Ford Focus MK2 Cup Holder Adapter preview

Files (1)

Full_FocusCup_Main.stl

STL

6.3 MB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	ASA / PETG 20%	ASA / PETG 25%	100% solid	Recommendation
Full_FocusCup_Main.stl	Primary model	6.3 MB STL	Slice file	Slice file	Slice file	Print with a brim for stability

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Ford Focus MK2 Cup Holder Adapter

0 downloads14 views0 quality score

Print this part

Check the available model and saved setup details before opening your slicer.

Files

1 hosted model file

STL

Material

ASA or PETG for heat resistance

Print time

Slice to calculate

Filament

Slice to calculate

Supports

verify in slicer

Infill

20-30% infill for durability

Difficulty

Not rated — inspect geometry

Vehicle heat

Cabin/interior use; avoid high-heat zones

Open the STL, 3MF, or OBJ model in your slicer before printing. Confirm orientation, supports, print time, filament use, and printer compatibility. Test-fit before installing it in a vehicle.

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

The Ford Focus MK2 has a pretty terribly designed cup holder, and with todays drink sizes it fall short quite a bit. I've designed this cup holder adapter that solves this issue and can hold up to a 10cm diameter bottle, and moves the holder forward so that the arm rest does not impede the cup holders ability to do its job. I'd recommend printing this in ABS or ASA, for heat resistance. Or at the very least printed in PETG. For smaller printers like the ENDER 3 I've split the model into separate parts that can be glued together post printing. You will need to print 2 of the “ring” STL files to glue onto the bottom side.