Ford Focus ST center console tray preview

Files (1)

Ford_Focus_center_console_tray_with_ST_logo_v2.stl

STL

107.8 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Ford_Focus_center_console_tray_with_ST_logo_v2.stl	Primary model	107.8 KB STL	Slice file	Slice file	Slice file	Check the orientation and supports in your slicer for optimal printing

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Center Console

Ford Focus ST center console tray

0 downloads18 views0 quality score

Print this part

Check the available model and saved setup details before opening your slicer.

Files

1 hosted model file

STL

Material

PETG or ASA for durability in car conditions

Print time

Slice to calculate

Filament

Slice to calculate

Supports

verify in slicer, but likely needed for the small ledges/tabs at the top

Infill

20-30% infill for a balance of strength and weight

Difficulty

Not rated — inspect geometry

Vehicle heat

Cabin/interior use; avoid high-heat zones

Open the STL, 3MF, or OBJ model in your slicer before printing. Confirm orientation, supports, print time, filament use, and printer compatibility. Test-fit before installing it in a vehicle.

License & use

CC BY

Commercial use allowed

Attribution required

Safety/IP review

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

This is a remix of the Focus RS console tray by majingrim here: https://www.thingiverse.com/thing:3769851 I also used the ST logo text created by JackHydrazine here: https://www.thingiverse.com/thing:3849541 (but scaled down to 80% size) This should fit 2015-2018 Ford Focus STs. The "ST" text is very slightly lower (~0.5 mm) than the surrounding bottom of the tray, but it is clearly visible. I figured this would be a good depth to avoid trapping too much dirt and also allow for some contrasting paint in the future. The small ledges/tabs at the top of the part may be a challenging overhang for some printers, so use supports if you you want it to be perfect. I did not use supports and one layer of material was loose/sagging, but is hard to notice unless you look carefully and did not affect the fit in the vehicle. I was told EU vehicles need to have the notch on the other side so there is also a mirrored version (except for the "ST" text).