Files (1)

Mondeo_mk4_mount.stl

STL

464.9 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 90%	100% solid	Recommendation
Mondeo_mk4_mount.stl	Mount / bracket	464.9 KB STL	Slice file	Slice file	Slice file	Use a brim or raft if the model's edges tend to curl off the build plate

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Ford Mondeo MK4 Mount

0 downloads46 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

I bought a 2012 MK4 Ford Mondeo and realised there was nowhere sensible to mount a mobile phone. As I had the 'power' start button my trim was all one piece so I decided to design my first thing! It does involve opening the dash a little but this was to stop it from sliding out, I managed to do it but pulling the start button edge trim off and gently unscrewing the 2 screws behind just enough to lean the dashboard forward slightly. Made the base of the ball a little thicker and even though the right side (bottom when printing) of the ball didn't print perfectly it still works well. Add a little black foam pad beneath the bottom support to stop it scratching the dash. Printing: Printed in Black PLA as ABS just kept warping and causing the ball to fail. 100% infill for strength Support from buildplate I used a raft due to the small edges slightly curling off the bed but not required.