Ford Ranger PJ/PK modular switch panel preview

Files (1)

button_panel.stl

STL

210.6 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
button_panel.stl	Primary model	210.6 KB STL	Slice file	Slice file	Slice file	Ensure proper fit and clearance before printing to avoid modifications

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Ford Ranger PJ/PK modular switch panel

0 downloads39 views0 quality score

Print this part

Check the available model and saved setup details before opening your slicer.

Files

1 hosted model file

STL

Material

PETG or ASA for durability in automotive conditions

Print time

Slice to calculate

Filament

Slice to calculate

Supports

verify in slicer

Infill

20-30% infill for strength and moderate weight

Difficulty

Not rated — inspect geometry

Vehicle heat

Cabin/interior use; avoid high-heat zones

Open the STL, 3MF, or OBJ model in your slicer before printing. Confirm orientation, supports, print time, filament use, and printer compatibility. Test-fit before installing it in a vehicle.

License & use

Public Domain

Commercial use allowed

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

Fits 6x standard Carling 32x21mm switches or essentially anything which fits the measure. My current setup includes the following: 5x https://www.aliexpress.com/item/1005003506138964.html 1x https://www.aliexpress.com/item/1005007982389122.html The panel is modular which means you can attach more useful things to the face-plate, the left and right side and also the bottom. On the attached demo photo I have attached a CB radio mount to the bottom modular area. HIROYASU CB-1011 CB Walkie Talkie 27MHz 40Ch FM/AM 8W Mini 26.565-27.99125MHz Mobile Radio for EU PL DE CE UK IN US IT Countries - AliExpress 509 For the assembly you need at least 4x screws to hook up the panel to the ceiling bracket and for the full modular additional 12x screws. I have used those very generic M4x10 PC fan screws, but I could only assume that anything fits really. https://www.aliexpress.com/item/1005003576210952.html Installation: Measure the hole you need to cut into the ceiling liner. It is easiest to measure the inner dimensions of the top_mount and use that. I made a 115x180mm opening to my liner. Attach one side_clip to each side of the top_mount using two screws. Make sure the top_mount (with side_clips on it) fits nicely inbetween the metal and the liner and then glue it to the metal. Run your wiring loom from the panel, between the body and the liner towards the front left A-pillar and use the plastic as the cover to get the wiring loom under the dashboard. Fasten the panel to the glued top_mount using two screws.