Files (2)

Left_Light_Mount.stl

STL

13.9 KB

Right_Light_Mount.stl

STL

14.5 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Left_Light_Mount.stl	Choose left variant	13.9 KB STL	Slice file	Slice file	Slice file	Small functional file: print slowly; consider 80–100% infill for durability.
Right_Light_Mount.stl	Choose right variant	14.5 KB STL	Slice file	Slice file	Slice file	Small functional file: print slowly; consider 80–100% infill for durability.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Grilles

Ford Raptor LED Bracket

0 downloads45 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is my first Thing upload. Just a crude LED bracket to mimic the Ford Raptor grille led lights. It was printed in two pieces and then super glued together. It was designed to fit behind a 2018 F150 King Ranch Grille. I was able to install this without pulling the grille off the truck. I just had to pop off the radiator cover to run wires. It may fit behind others. Open the file with a software you can measure with and check dimensions to see if it will fit your grille. I drilled through it when I picked my mounting holes, and it drilled the PLA just fine. The pictures of it installed look crooked, but it was the way I held my phone. I bought led's from amazon: https://www.amazon.com/gp/product/B01IR3G474/ref=ppx_yo_dt_b_asin_title_o02__o00_s00?ie=UTF8&psc=1. Hopefully this simple bracket can help you with your project! It was a fun first design to print.