Files (1)
Slice the required model files; source file size is not printable volume.
Use the slicer's filament total; STL/3MF byte size is not a cost input.
Slice with the recommended material, infill, orientation, and supports.
| STL file | Role | Source size | ASA / PETG 20% | ASA / PETG 95% | 100% solid | Recommendation |
|---|---|---|---|---|---|---|
| Indicator_Cable_Bracket_v2_v2.stl | Mount / bracket | 56.8 KB STL | Slice file | Slice file | Slice file | Use a raft if necessary, but it might not be required |
Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.
Ford Shift Indicator Bracket reinforced
Shared by
3DPrintedCarPartDescription
I had some problems with these being too fragile, so I beefed them up a little bit. Then I used FormFutura ApolloX ASA filament and these seem very strong now. I used a raft when printing, but it might not be necessary. I also increased the wall thickness to make these pretty much solid when I printed them. 250 nozzle and 90 for the bed. Supports are required, and I recommend turning down the percent for the support to make it easier to remove without breaking the part.
Compatible Cars
Originally published on thingiverse.com by Eric Haslip (brotherhaslip) · License: CC BY
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Related Parts
Finding specific fitment/category matches first.
