Files (1)

Ford_Window_Knob_v1.stl

STL

1.6 MB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Ford_Window_Knob_v1.stl	Primary model	1.6 MB STL	Slice file	Slice file	Slice file	Ensure proper fit on the window crank handle before printing

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Knobs/Buttons

Ford Window Crank Knob

0 downloads40 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

The window crank on my 1996 Ford Ranger was missing the knob so I tried to copy the original one from the passenger side and this is what I came up with. It works great! Saved me $15 from having to buy an aftermarket replacement. This may fit other Fords with a manual window crank as well. To install, slip onto the handle, then heat up and "mushroom" over the post from the backside, essentially "riveting" it into place whilst allowing it to rotate freely. As always, if you make one, all I ask is that you please share a photo or at least comment on how it worked for you!