Ford XR4 (ST150) Wheel Centre Cap for 17" Factory Rims - image

Files (1)

XR4_Wheel_Centre_Cap_v0.4.stl

STL

5.5 MB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
XR4_Wheel_Centre_Cap_v0.4.stl	Cover / cap	5.5 MB STL	Slice file	Slice file	Slice file	Use PETG / ASA; check sealing faces and verify in slicer.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Emblems/Badges

Ford XR4 (ST150) Wheel Centre Cap for 17" Factory Rims

0 downloads34 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is my design for an 2007 Ford Fiesta XR4 Wheel Centre Cap for the factory 17" rims. It was generated from scratch on FreeCAD 0.18 for Windows x64. The factory centre caps are known to pop out and get lost, so they are starting to get rare and expensive. This will clip into the factory rim and clear the wheel nuts. I have set this to a high polygon count so that the face can be as smooth as possible. I print with the clips down, outward face up, with full supports. It gets a bit messy underneath, but since it is not visible that does not bother me. I've only printed this on PLA so far for test fitting - I'd love to see the results and get some tips on how best to print and finish this. Note that it has XR4 in the centre embossed on the front face using a trueType Font that I created from scratch from factory badges. The centre depression is a tidy 65mm, so a 65mm Ford Gel Sticker (available on eBay or Aliepxress) would go well here and cover that up for the overseas cars, which are known as the ST150 in every other market but Australia.