Ganador Mirror pin for FD3S Mazda RX-7 - image

Files (1)

Body1.5.stl

STL

1.5 MB

Print guidance estimate

Estimated from part metadata

Print cost & setup estimate

Planning numbers for filament, cost, time, and setup. Treat them as estimates until you confirm the file in your slicer.

1 model file

Recommended kit

36g

Based on 25% main infill across listed model files

Material cost

$0.87

Filament only at roughly $24/kg PETG / ASA

Print time

1.0h–1.7h

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Body1.5.stl	Primary model	1.5 MB STL	33g $0.80	36g $0.87	80g $1.91	Ensure the printed pin's outer diameter is between 7.13-7.19mm for proper threading

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Mirror Covers

Ganador Mirror pin for FD3S Mazda RX-7

0 downloads44 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is the pin/screw that holds the glass onto the body of the mirror. The one that comes with these usually is rubber and breaks easily. You may find that when you install the pin into the plastic which holds your mirror, if it doesn't snap easily. If this is the case shave it a little until it fits. Reason being is that these holes can become worn out so i made this design a little bigger to give you room for adjustment. Your final print must be 7.13-7.19 (the screw) OD in order to thread without binding or being too lose.