Files (1)
Slice the required model files; source file size is not printable volume.
Use the slicer's filament total; STL/3MF byte size is not a cost input.
Slice with the recommended material, infill, orientation, and supports.
| STL file | Role | Source size | PETG / ASA 20% | PETG / ASA 25% | 100% solid | Recommendation |
|---|---|---|---|---|---|---|
| iEteB4aSAGA.stl | Primary model | 219.6 KB STL | Slice file | Slice file | Slice file | Print with a brim for improved adhesion |
Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.
GPSMount2
Shared by
3DPrintedCarPartDescription
So I wanted a low-profile mount for my Garmin LMT 50 to put in my Jeep and I came up with the laughing Pinocchio. He requires a piece of 2-sided gel tape under his nose and hooks onto the center of the dash above the stereo. The ball is 17mm and the GPS has a dash cam so it sits pretty much straight. I printed him at 95% and with supports. I printed on its side. May not work in very hot vehicles/climates unless you switch to ABS.
Compatible Cars
Originally published on thingiverse.com by Sean Campbell (IronCanine) · License: CC BY-SA
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Related Parts
Finding specific fitment/category matches first.
