Files (1)

Hook_2.0.STL

STL

227.5 KB

Print guidance estimate

Uses saved filament metadata

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

50g

Based on 25% main infill across listed model files

Material cost

$1.20

Filament only at roughly $24/kg ASA / ABS

Print time

2.0h saved / 1.4h–2.4h estimate

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	ASA / ABS 20%	ASA / ABS 25%	100% solid	Recommendation
Hook_2.0.STL	Primary model	227.5 KB STL	46g $1.10	50g $1.20	110g $2.63	Print with a slow speed and warm temperature for optimal layer adhesion

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Interior

Headrest Hook

0 downloads193 views0 likes

Shared by

Michael Chen

Verified

Description

I find that giving kids a place to put things is the easiest way to get them to organize on their own. I recognized that my daughter had a place for everything in my car except her backpack which ended up on the floorboard where it was inevitably stepped on or forgotten. My solution is this hook. It simply grabs one of the posts of the headrest in front of the car seat. It keeps bags off the floor and gives the little people a roll in keeping the car clean. Print slow and warm for best layer adhesion. I suggest a material like ASA or ABS to take the heat of the car in the sun and maintain the abuse of being used daily.