Files (1)

Headrest_Hook_Remix.stl

STL

755.6 KB

Print guidance estimate

Uses saved filament metadata

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

50g

Based on 25% main infill across listed model files

Material cost

$1.20

Filament only at roughly $24/kg PETG / ASA

Print time

2.0h saved / 1.4h–2.4h estimate

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Headrest_Hook_Remix.stl	Primary model	755.6 KB STL	46g $1.10	50g $1.20	110g $2.63	Print with a slow speed to avoid needing supports

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Interior

Headrest Hook

0 downloads204 views0 likes

Shared by

Michael Chen

Verified

Description

Quick and dirty remix of the wonderful "Chained Headrest Hook". The original hook tended to fall from the headrest when not in use, so i closed the upper hook to a ring 13mm in diameter, maybe to small for other purposes than the backseat headrests of a suzuki swift, please measure first. Next problem was: it was a bit too long, so the bags i hang there stood on the floor of the trunk. Solution: Shortened it by one element. Print as is. No support needed if printed slow enough.