Files (2)

Honda_Emblem_Curved.stl

STL

624.0 KB

Honda_Emblem_Flat.stl

STL

610.6 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Honda_Emblem_Curved.stl	Printable file	624.0 KB STL	Slice file	Slice file	Slice file	Use a brim or raft for improved adhesion to the print bed
Honda_Emblem_Flat.stl	Printable file	610.6 KB STL	Slice file	Slice file	Slice file	Use a brim or raft for improved adhesion to the print bed

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Emblems/Badges

Honda Civic 2008 Front Emblem

1 downloads78 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Replacement "H" for the my 2008 Honda Civic 4 door Sedan. One is flat and won't fit to the curved surface on the car properly but it prints really well. If you print with PLA it is very easy to add the curve by heating it. The second version is curved and I haven't printed it, I just made a curved version of the flat one and added the two pins, about 2mm long. You will need supports for this one.