License Plate Partial Frames - Trueno and Type R - image

Files (3)

TruenoPlateBottom.stl

STL

35.4 KB

TruenoPlateTop.stl

STL

35.4 KB

TypeRPlateBottom.stl

STL

31.9 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

3 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
TruenoPlateBottom.stl	Printable file	35.4 KB STL	Slice file	Slice file	Slice file	Orient the model to minimize supports, if possible.
TruenoPlateTop.stl	Printable file	35.4 KB STL	Slice file	Slice file	Slice file	Orient the model to minimize supports, if possible.
TypeRPlateBottom.stl	Printable file	31.9 KB STL	Slice file	Slice file	Slice file	Orient the model to minimize supports, if possible.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Emblems/Badges

License Plate Partial Frames - Trueno and Type R

0 downloads39 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Top and bottom Trueno badge partial frames and a bottom Type R partial frame. I use the top Trueno frame since that's where the actual Trueno badge would sort of be. I think the base is 5mm thick, but 3mm worked for me. It could probably go thinner. Just move the model a bit below the build plate.