Files (1)

Automotive_Tubing_Snap_Clamp_v3.stl

STL

406.9 KB

Print guidance estimate

Estimated from part metadata

Print cost & setup estimate

Planning numbers for filament, cost, time, and setup. Treat them as estimates until you confirm the file in your slicer.

1 model file

Recommended kit

50g

Based on 25% main infill across listed model files

Material cost

$1.20

Filament only at roughly $24/kg PETG / ASA

Print time

2.0h saved / 1.4h–2.4h estimate

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Automotive_Tubing_Snap_Clamp_v3.stl	Primary model	406.9 KB STL	46g $1.10	50g $1.20	110g $2.63	Ensure proper orientation for optimal strength and snap fit functionality

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Exterior

Honda tubing snap clip

0 downloads210 views0 likes

Shared by

Michael Chen

Verified

Description

This was designed to hold the steering fluid low pressure return line for a 2004 Honda Accord. The pipe size is 10mm O.D. This is not a copy of the original. It is an improvement. Extra material was added where the OEM version would break. Works for many different Honda years and models. It snaps into factory made holes in frame and also snaps down onto pipe. Please! Print a make to show you used it and like it :) Please make sure pipe is in correct place before snapping in. It will hold the pipe very well, but if there is too much force from a line not properly positioned, it will break. It is stronger than original but is still just plastic.