iPhone 6 Plus holder on VW Tiguan - image

Files (1)

iPhone-6-plus-card-holder.STL

STL

951.0 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
iPhone-6-plus-card-holder.STL	Mount / bracket	951.0 KB STL	Slice file	Slice file	Slice file	Ensure the holder is securely attached to the car to prevent it from falling

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

iPhone 6 Plus holder on VW Tiguan

0 downloads32 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

I made the holder for iPhone 6 first, and enlarged for fit the iPhone 6 plus also. I didn't print it out but if you make this please feedback here then I can (or you can) make it even better, enjoy! Inside is a little bit bigger than iPhone6 plus, it's 163mm. ===UPDATE 2018/03/21=== Here is the smaller holder for iPhone 6 / 7: https://www.thingiverse.com/thing:694199