Files (2)
Slice the required model files; source file size is not printable volume.
Use the slicer's filament total; STL/3MF byte size is not a cost input.
Slice with the recommended material, infill, orientation, and supports.
| STL file | Role | Source size | PETG / ASA 20% | PETG / ASA 25% | 100% solid | Recommendation |
|---|---|---|---|---|---|---|
| Visor_v1.obj | Accessory piece | 15.5 KB OBJ | Slice file | Slice file | Slice file | Small functional file: print slowly; consider 80–100% infill for durability. |
| Visor_v1.stl | Printable file | 82.5 KB STL | Slice file | Slice file | Slice file | Use adhesion brim or raft for better print adhesion |
Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.
Isuzu Sun Visor Tube Halfshells
Shared by
3DPrintedCarPartDescription
This is a replacement for the plastic bit for the late 90's-2000's Isuzus on the sun visor that holds it in place within the clip. Printed two as half shells, sliced with Cura and with adhesion brim/raft enabled. Printed on slightly raised rectangles that are part of the model, lightly sanded with 220 grit to clean up the glue faces. Gorilla Gel super glue worked for the application. Dab on each side, clamped for 60 seconds and it is good to go. Can easily be sanded smooth if the fit is too tight. Files provided should allow you to modify it for your application.
Compatible Cars
Originally published on thingiverse.com by Mark Chervony (MarkBuildPrint) · License: CC BY
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Related Parts
Finding specific fitment/category matches first.
