Jack Stand Pad for BMW vehicle

This is a pad designed to fit into a BMW car's jacking block so that you can lift your car without damaging it. It should be a nice snug fit. It can be used with regular harbor freight type jack stands with an upwards curved top. The width of the top can be 25mm (1 inch) maximum. Message me if you need a version with a wider top section or different curvature radius. Print with at least 60% infill and 4 layers on the outer walls for stability. No supports needed. Just print the part the way it is with the flat side facing down. DISCLAIMER Please keep in mind that jacking your car up and working underneath it is very dangerous and can lead to serious injury or death. Make sure that you know what you're doing. I take no responsibility for any injuries caused by using this model. If in doubt, don't use it!