Files (2)

Jeep_Rear_bumper_cap_fixed_TEST.stl

STL

149.6 KB

Jeep_Rear_Bumper_cap_fixed_V6.stl

STL

319.0 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Jeep_Rear_bumper_cap_fixed_TEST.stl	Cover / cap	149.6 KB STL	Slice file	Slice file	Slice file	Use PETG / ASA; check sealing faces and verify in slicer.
Jeep_Rear_Bumper_cap_fixed_V6.stl	Cover / cap	319.0 KB STL	Slice file	Slice file	Slice file	Use PETG / ASA; check sealing faces and verify in slicer.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Rear Bumper

Jeep TJ Rear Bumper End Cap

0 downloads48 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Remix of 2340538 I created a tapered endcap from this original design. It fits well in the rear bumper of my 2002 Jeep TJ. I need to lengthen and increase the thickness around the bolt holes. Printed in PLA PRO. I will update it. I included the test fit one as it prints in less time. Print as downloaded for left side, reverse in CURA for right side. I rotate to largest flat side to print, with supports and brim.