Files (1)

Jeep_Vent.stl

STL

31.0 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Jeep_Vent.stl	Primary model	31.0 KB STL	Slice file	Slice file	Slice file	Ensure proper orientation in the slicer to minimize supports

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Vents

Jeep Wrangler JL Vent Support

0 downloads32 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is an insert to go into a Jeep Wrangler HVAC vent to prevent it from falling down when using a vent clip phone holder. I'm using a Kenu Airframe Pro to hold my iPhone 12 Pro Max and the weight of the mount + phone doesn't allow the phone to stay upright. Enter the vent support. Slide it in at the bottom and you're good to go. I included a little pull handle in the event you want to remove it. Print with supports for the pull handle.