Files (1)

Jeep_Vent.stl

STL

465.7 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	ASA / ABS 20%	ASA / ABS 25%	100% solid	Recommendation
Jeep_Vent.stl	Primary model	465.7 KB STL	Slice file	Slice file	Slice file	Print with the vent standing up on its edge for best results

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Vents

Jeep Wrangler Vent

0 downloads50 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Best results I've gotten so far is to print standing up on the edge without the little hole. I printed in PLA with 20% infill. First go-round the PLA was warped by the heat of the air coming out of the vent. Recommend printing in ABS or other plastic with higher melting point.