Jeep Wrangler TJ Lower Switch Panel preview

Files (1)

Switch Bkt Rev 6 v5.stl

STL

64.8 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Switch Bkt Rev 6 v5.stl	Primary model	64.8 KB STL	Slice file	Slice file	Slice file	Print the brackets mirrored for proper assembly.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Jeep Wrangler TJ Lower Switch Panel

0 downloads18 views0 quality score

Print this part

Check the available model and saved setup details before opening your slicer.

Files

1 hosted model file

STL

Material

PETG or ASA for durability in a car environment

Print time

Slice to calculate

Filament

Slice to calculate

Supports

verify in slicer

Infill

20-30% infill for a balance between strength and weight

Difficulty

Not rated — inspect geometry

Vehicle heat

Cabin/interior use; avoid high-heat zones

Open the STL, 3MF, or OBJ model in your slicer before printing. Confirm orientation, supports, print time, filament use, and printer compatibility. Test-fit before installing it in a vehicle.

License & use

Public Domain

Commercial use allowed

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

This is a three part panel that uses #10-32 screws and captured nuts to hold on the faceplate. This allows for easy access to the switches and wiring. Print the brackets mirrored and one face panel. Or cut the face panel out of wood, aluminum or carbon for a more rigid and long lasting part. The panel is sized for the Carling rocker switches and the standard Amazon round power plugs / USB ports.