Slice the required model files; source file size is not printable volume.
Use the slicer's filament total; STL/3MF byte size is not a cost input.
Slice with the recommended material, infill, orientation, and supports.
| STL file | Role | Source size | ASA / ABS 20% | ASA / ABS 35% | 100% solid | Recommendation |
|---|---|---|---|---|---|---|
| No printable model files are available for an estimate yet. | ||||||
Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.
Land Cruiser 200 - Auxbeam Switch Panel - Sunglasses Flip Down Insert Bezel
Shared by
3DPrintedCarPartDescription
This is a bezel that takes the place of the flip-down sunglasses holder in the Toyota Land Cruiser 200. Made for the Auxbeam 8-switch panel (Amazon link below). Pops into place of the sunglasses insert. The flip down portion is 2-pieces and this takes the place of one piece. Requires drilling a hole in the main plastic panel for the cable to pass through and move back and forth with the flip down. Recommend printing with ASA or ABS or some other high-temperature plastic. PLA would likely melt in the summer time in most places. I've printed anywhere from 0.15 to 0.3mm layer heights with good results. Also had the best success with supports on build plate since the bottom has an upward angle in one section to account for the curve of the piece that this fits in to. https://www.amazon.com/dp/B08FQTCLZG
Compatible Cars
Originally published on thingiverse.com by Sammy Nicotine (sw682) · License: CC BY-NC-SA
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Related Parts
Finding specific fitment/category matches first.
