Mitsubishi immobilizer car key coil extender - image

Files (2)

keyholder-coil.stl

STL

28.0 KB

keyholder-faceplate.stl

STL

48.9 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
keyholder-coil.stl	Mount / bracket	28.0 KB STL	Slice file	Slice file	Slice file	Ensure proper electrical connection to the genuine Mitsubishi immo coil
keyholder-faceplate.stl	Mount / bracket	48.9 KB STL	Slice file	Slice file	Slice file	Ensure proper electrical connection to the genuine Mitsubishi immo coil

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Mechanical/Functional

Mitsubishi immobilizer car key coil extender

0 downloads51 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

I've installed a "Start/Stop engine button" kit over the place of key cylinder. To retain immobilizer capability I've designed this "extender". The hole in the coil fits my Mitsubishi transponder key. The frame over the coil fits my car's panel dummy cap dimensions. The coil is electrically connected to a wire been wrapped around genuine Mitsubishi immo coil located on top of the key cylinder. I've tested this extender and it works great!