MK7 GOLF GTI Licence Plate holder - image

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

0 model files

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
No printable model files are available for an estimate yet.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

MK7 GOLF GTI Licence Plate holder

0 downloads56 views0 likes

Download at source

Shared by

3DPrintedCarPart

Verified

Description

Designed to fit Volkswagen Golf GTI Mark 7 only, this will most likely not fit any other models. All you need is 4x 1-1/2 wood screws, and potentially some Vinyl foam tape to protect the front grill from marking the car grill. This has been design to minimize print time, increase strengh, and does not block the air intake. Please place exactly as depicted on the pictures, with the GTI MK7 on the top right corner. There are more holes than needed predrilled on the rear mounting piece, just use 4 as depicted by the red or blue rectangle that will align with the licence plate holder. I have used licence plates templates from different provinces of Canada, but also the US so this should accomodate most of them. Update 1: I replaced the "TOP" by "MK7 GTI", just for cosmetic reason.