Golf III glove box hinge hooks support

Files (2)

golf_gchook_ns.stl

STL

153.4 KB

golf_gchook_s.stl

STL

212.8 KB

Reference shelf

Recommended filament for this print

Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.

Referenced item	What to verify	Price & availability
PETG filamentAmazon · Affiliate link	Amazon product page for 1.75 mm PETG; confirm colour, spool size, print temperature, seller, and delivery region.	Check price at Amazon
ASA filamentAmazon · Affiliate link	Amazon product page for 1.75 mm ASA; use an enclosure and suitable ventilation, and confirm seller and regional availability.	Check price at Amazon

Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.

3 downloads549 views0 quality score

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

mar sky (mar-sky)

Designers selling from the US, Canada, the UK, the EU/EEA (except Iceland), Switzerland and Gibraltar can also list separate original designs for sale and receive 80% of the listing price, paid out by Stripe in your local currency (conversion fees may apply). Claiming credits you here; it doesn't put this imported part up for sale.

Description

Golf III glove box hinge. You need to print 2 of these. They break during time and especially if lid is open often. Attached versions are with supports and no-supports. Made the design based on the original part and there is a spring like part in one end. However if your printer cannot print it well (to make its strong) the spring part does not actually matter becouse the hinge works with or without it. -printing: I used 0.25mm and 25 % infill. More infill = stronger. -installing into car's glove box: a bit tricky 1) I removed glove box it is simple with few screws in easy locations 2) use flat screwdriver to be able insert the hinge to the lid opening (the part with coffee cup holders). I did by inserting the hook-end first through the hole. 3) look for the position where you slightly pull and snap the hinge to the correct place 4) finally insert the "hook end" into glove box holes. DONE and you can drive another 5-10 years hopefully with your Golf III, before renewing these!