Files (3)

brace.stl

STL

25.9 KB

espspacer.stl

STL

70.8 KB

pin.stl

STL

10.0 KB

Print guidance estimate

Estimated from part metadata

Print cost & setup estimate

Planning numbers for filament, cost, time, and setup. Treat them as estimates until you confirm the file in your slicer.

3 model files

Typical selected file

12g

Based on 25% main infill for the largest likely-needed model file

Material cost

$0.29

Filament only at roughly $24/kg PETG

Print time

21m–34m

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG 20%	PETG 25%	100% solid	Recommendation
brace.stl	Printable file	25.9 KB STL	9g $0.21	9g $0.23	21g $0.50	Ensure proper fit and orientation in the slicer before printing
espspacer.stl	Printable file	70.8 KB STL	11g $0.27	12g $0.29	26g $0.64	Ensure proper fit and orientation in the slicer before printing
pin.stl	Accessory piece	10.0 KB STL	8g $0.20	9g $0.22	20g $0.47	Small functional file: print slowly; consider 80–100% infill for durability.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Interior

USB Port for Golf V [5]

3 downloads514 views0 likes

Shared by

Alfred

Verified

Description

I have made this drop-in replacement for these unused button placeholders where I inserted some USB fast charging adapters from amazon They are wired to the 12V input of the cigarette lighter. You need to insert the USB PCB and put the brace around the USB port, then press it into place and use a vise or pipe grippers to press the pins in place. To disassemble, you can warm up a paperclip and insert it into the pin. Wait for it to cool down and use a bit of force to remove the pin from the hole.