Files (1)

Instrumentenhalter.stl

STL

147.5 KB

Print guidance estimate

Estimated from part metadata

Print cost & setup estimate

Planning numbers for filament, cost, time, and setup. Treat them as estimates until you confirm the file in your slicer.

1 model file

Recommended kit

15g

Based on 25% main infill across listed model files

Material cost

$0.36

Filament only at roughly $24/kg ASA / ABS

Print time

26m–43m

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	ASA / ABS 20%	ASA / ABS 25%	100% solid	Recommendation
Instrumentenhalter.stl	Primary model	147.5 KB STL	14g $0.33	15g $0.36	33g $0.79	Ensure proper fitment in the Golf MK5 air outlet before printing

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Interior

VW GOLF MK5 GAUGE HOLDER

1 downloads79 views0 likes

Shared by

Alfred

Verified

Description

This Thing is an Gauge Holder for 52mm Gauges! so every common Aftermarket Gauge fits! its specificly for the Golf MK5 Airoutlet on the left side (probably fits the right site too) You just replace the original fins with this piece and you are ready to go. Dont print it in PLA, ABS only!! because of the heat in the car on warm Summerdays PLA deforms.