Model X Wireless Charger (Pre 2020 refresh) - image

Files (2)

model_x_wireless_charger_v3.3mf

3MF

43.5 KB

model_x_wireless_charger_v3.stl

STL

157.4 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
model_x_wireless_charger_v3.3mf	Printable file	43.5 KB 3MF	Slice file	Slice file	Slice file	Print with the model face down on a glass bed for optimal results
model_x_wireless_charger_v3.stl	Printable file	157.4 KB STL	Slice file	Slice file	Slice file	Print with the model face down on a glass bed for optimal results

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Model X Wireless Charger (Pre 2020 refresh)

0 downloads25 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a wireless magsafe charger for a Tesla Model X (before the 2020 refresh). It fits nicely in the phone slot in the center console of the Model X. I've tested it in a 2019 Model X and with both an Iphone 14 pro and 13 pro. To make this, you will need the following: 1. A puck-style magsafe wireless charger. The one I chose is https://www.amazon.com/dp/B0B6ZK81WH. If you choose another wireless charger, you may need to alter the model to fit your charger. 2. Hot-glue. 3. One of the included model files. (Both are the same, I just provided multiple formats) I printed the model face down on a glass bed with support. After printing, simply glue the charger in place and glue any excess wire out of the way. This model was inspired by this product that I saw online: https://greenmissionstore.com. I didn't buy their charger, but I thought I would give them a shout-out.