Files (2)

GT350_clip_tool_v1.0.stl

STL

685.9 KB

GT350_clip_tool_v2.stl

STL

8.0 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
GT350_clip_tool_v1.0.stl	Clip	685.9 KB STL	Slice file	Slice file	Slice file	Print with the thin edge up to minimize supports
GT350_clip_tool_v2.stl	Clip	8.0 KB STL	Slice file	Slice file	Slice file	Small functional file: print slowly; consider 80–100% infill for durability.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Tools & Jigs

Mustang GT 350 Spoiler Tool

0 downloads69 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This trim tool was created specifically to gently remove the front spoilers of the Ford Mustang GT 350 and GT 350 R. Ford uses the same nasty one way installation clips on both the 1-piece and 3-piece front spoiler. The front spoiler needs to come off any time the large plastic chassis shield needs removal, including the current Recall on oil cooler hoses. Also, the spoiler needs to be removed to safely load the car onto a transport vehicle. When using the tool it's obviously thin and not meant to take any load other than straight on. Start from one side and work towards the center, it should pop off after the first angled clip is released. I've used it on 8 different cars and broken it once but that car's spoiler was particularly stuck.