Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

0 model files

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
No printable model files are available for an estimate yet.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Trunk/Tailgate

Mustang Trunk Panel Fastener

0 downloads43 views0 likes

Download at source

Shared by

3DPrintedCarPart

Verified

Description

This is a replacement fastener for the rear trunk panel (the panel inside the trunk, covering the tail lights) for a 2005-2009 Ford Mustang. It may very well be used in other years and models as well. The factory part is made to just push in, and unscrew to remove. After several cycles of removal/installation, the tangs that catch the threads tend to wear out and it won't stay in place on the threaded stud any longer. Not sure what these cost at the dealer, but they're about $8 each plus shipping from the aftermarket. Instead of spending $20+ to replace them, I just modeled them and printed up a couple.