Trunk Retainer (2005-09 Ford Mustang) - image

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

0 model files

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
No printable model files are available for an estimate yet.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Trunk/Tailgate

Trunk Retainer (2005-09 Ford Mustang)

0 downloads62 views0 likes

Download at source

Shared by

3DPrintedCarPart

Verified

Description

Replacement for the trunk retainer hardware in a 2005-2009 Ford Mustang. This screws onto a tail-light bolt to hold the trunk trim in place. The OEM retainer (see 2nd picture) is expensive and breaks often. Just modeled, printed, and installed this in my trunk, so we'll see how it holds up. The hole is 7/32" (5.56 mm) and the bolt it screws on to is 6mm. I have aftermarket tail-lights so you may need a larger / smaller hole (use a drill or scale the model slightly). I installed two of these: one was tapped and one wasn't. Both worked fine. Tighten using a 15mm socket wrench.