MX5 AEM Wideband Gauge Vent Mount - image

Files (1)

AEM_WidebandHolder.stl

STL

324.3 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
AEM_WidebandHolder.stl	Mount / bracket	324.3 KB STL	Slice file	Slice file	Slice file	Ensure proper ventilation when printing with PETG or ASA

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Vents

MX5 AEM Wideband Gauge Vent Mount

0 downloads38 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

I made this design so I could fit my AEM Wideband O2 controller into one of my "eye ball" air vent inlets in my 2002 MX-5 NBFL. It is compatible with all MX-5s from 1990 to 2004, as far as I know these models had the same vent holes. I printed it on my Creality LD-002H SLA printer, with 85% support from baseplate. I don't think, that this would be too good with an FDM printer, but I didn't try it. If you find this model useful and is a help for you, consider leaving a tip of a few bucks, I would be very grateful. For hungarians: // Ha magyar mazdás csopikban meglátom, hogy valaki árulni fogja ezt nyomtatásra, akkor részesedést kérek, mégis csak én modelleztem:D //.