Files (3)

LeafPhoneHolderBackInsertUnit.stl

STL

713.2 KB

LeafPhoneHolderS8_Light.stl

STL

921.3 KB

LeafPhoneHolderSocket.stl

STL

325.4 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

3 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
LeafPhoneHolderBackInsertUnit.stl	Mount / bracket	713.2 KB STL	Slice file	Slice file	Slice file	Ensure the base section fits securely in the panel below the Climate Controls.
LeafPhoneHolderS8_Light.stl	Mount / bracket	921.3 KB STL	Slice file	Slice file	Slice file	Ensure the base section fits securely in the panel below the Climate Controls.
LeafPhoneHolderSocket.stl	Mount / bracket	325.4 KB STL	Slice file	Slice file	Slice file	Ensure the base section fits securely in the panel below the Climate Controls.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Nissan Leaf phone holder

0 downloads27 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

I printed this phone holder to fit my Nissan leaf. The base section fits in the panel below the Climate Controls. This was a blank panel in my Australian Leaf, but it may be used for indicator lights in other countries. The holder has 3 parts. One part mounts to the dash (fixed in place by factory screws from the inside as shown in the photos. The second part pushes in to the base, and I used it to hold a QI induction charger. I bought the QI charger from Jaycar Electronis in Australia. https://www.jaycar.com.au/fast-wireless-qi-charger/p/MB3667 There's probably the same thing available in other countries. I took the cover off the charger and just used the internal bits. The last part is custom made to suit whatever phone you have. My one fits a Samsung Galaxy S8 with an Incipio cover. I tacked the phone holder to the induction charger mount with super glue, but it already holds in place fairly well by the 4 pins. I printed all parts in the orientation as shown. This meant that I'd get the best finish on the faces that you see when installed. I've included the Sketchup files so you can customise it to suit your needs.