Files (2)

Nissan_Leaf_dash_mount-RHD.stl

STL

324.8 KB

Phone_Holder_iphone_12mini.stl

STL

45.6 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Nissan_Leaf_dash_mount-RHD.stl	Mount / bracket	324.8 KB STL	Slice file	Slice file	Slice file	Ensure proper orientation in the slicer to minimize supports
Phone_Holder_iphone_12mini.stl	Mount / bracket	45.6 KB STL	Slice file	Slice file	Slice file	Ensure proper orientation in the slicer to minimize supports

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Nissan Leaf RHD phone mount

0 downloads34 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

I adjusted the very nice original for RHD (Simple mirror in 3d Builder) and altered the dimensions of the phone holder for a 12 Mini in a case. The way this holder clips to the dash in the Nissan Leaf is very nice. It sits over the hazard light switch perfectly and is held in place. Note - You just Superglue the two halfs together. There is a nice large flat surface so its nice and strong, Make sure you print with supports Credit to the original creator!