Files (2)

phone_holder.stl

STL

167.3 KB

phone_holder_cover.stl

STL

81.9 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
phone_holder.stl	Mount / bracket	167.3 KB STL	Slice file	Slice file	Slice file	Print the cover and main part separately for best results.
phone_holder_cover.stl	Cover / cap	81.9 KB STL	Slice file	Slice file	Slice file	Use PETG / ASA; check sealing faces and verify in slicer.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Nissan Magnetic Phone Holder

0 downloads34 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Loved the idea of magnetic phone holder. Changes from original 1) now uses nine (9) 8x4mm magnetcs. 2) Cover slides on instead of glue 3) Made the cover thinner where the magnets are, now it is 0.2mm thick I printed the cover first 3 layers at 0.1mm so I could get two (2) layers at the thin part. Then the rest of the layers on the cover at 0.2mm thick. The main part was printed at 0.2mm. If your slicer cannot switch layer heights mid print then just print the whole cover at 0.1mm just takes longer but gives best results on the thin area. I would recommend printing supports on the cover, but I forgot and it turned out just fine.:).