Files (3)

Abstandhalter_v4.STL

STL

1.4 KB

Fuesse_v4.STL

STL

12.2 KB

Seat_Handy_ablage_V4.STL

STL

16.6 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

3 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Abstandhalter_v4.STL	Accessory piece	1.4 KB STL	Slice file	Slice file	Slice file	Small functional file: print slowly; consider 80–100% infill for durability.
Fuesse_v4.STL	Accessory piece	12.2 KB STL	Slice file	Slice file	Slice file	Small functional file: print slowly; consider 80–100% infill for durability.
Seat_Handy_ablage_V4.STL	Accessory piece	16.6 KB STL	Slice file	Slice file	Slice file	Small functional file: print slowly; consider 80–100% infill for durability.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Seat Ateca Cell phone holder

0 downloads60 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

https://www.thingiverse.com/thing:4441076 presented a thumb screw to replace the wing nut on the front-left corner of the BIBO bed. It is too wide for the other two positions. I have created a smaller version to fit the right-front corner and the back-center. A M3-.50 nut is required. vor Samsung S20 od 176mmx 82mm.