Files (3)

Grip_pen_versie_5.stl

STL

14.8 KB

Grip_pen_versie_8.stl

STL

71.6 KB

Houder_versie_2.stl

STL

30.9 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

3 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Grip_pen_versie_5.stl	Accessory piece	14.8 KB STL	Slice file	Slice file	Slice file	Small functional file: print slowly; consider 80–100% infill for durability.
Grip_pen_versie_8.stl	Printable file	71.6 KB STL	Slice file	Slice file	Slice file	Use a tiny bit of glue for a secure grip
Houder_versie_2.stl	Printable file	30.9 KB STL	Slice file	Slice file	Slice file	Use a tiny bit of glue for a secure grip

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Seat Ateca & Moto G5 Plus

0 downloads42 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

*Update August 8th* Simple telephone holder for Moto G5 Plus with use in Seat Ateca. Goal was to have a simple holder in which the telephone could be inserted and taken out easily. Ofcourse it should be able to fit when the powercord is plugged. There are two ways to attach your holder to your vent: Option 1 (recommended): Grip pen versie 8; to rotate the phone a bit towards the driver and tilt it a bit forward. Relies on friction to stick. Option 2 Grip pen versie 5; simple lock as published originally. Clips into the back of the vent. Both options have been printed and tested and turned out ok. I prefer option 1 as it positions the phone a bit better towards the driver. Although the grip pens stick into the holder quite ok, I recommend a tiny bit of glue. And don't print in PLA! Heat *will* deform your beautiful print, even in moderate climates. Second print (the white one) was done this PETG and turned out perfect. Happy printing!