Smart ForTwo (451) Gauge Pod Neck - image

Files (1)

Gauge_Pod_Neck_v11.stl

STL

562.2 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Gauge_Pod_Neck_v11.stl	Primary model	562.2 KB STL	Slice file	Slice file	Slice file	Ensure a clean and smooth surface for bonding with contact cement

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Interior

Smart ForTwo (451) Gauge Pod Neck

0 downloads34 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

The neck section of the tachometer gauge pod became brittle and completely cracked, perhaps due to the sun. Rather than replacing the entire pod assembly, I disassembled the pod until I got to just the housing. I then used a dremel to clean the old neck area and finally sanded it smooth to get ready to accept the printed part. Once printed, I used a few drops of contact cement to hold everything in place. It worked like a charm.