Smart ForTwo 453 Rear Speaker Bracket - image

Files (2)

Left_speaker_holder_Smart_453_-_Pioneer_TS-G1030F.stl

STL

1.1 MB

Right_speaker_holder_Smart_453_-_Pioneer_TS-G1030F.stl

STL

1.1 MB

Print guidance estimate

Estimated from part metadata

Print cost & setup estimate

Planning numbers for filament, cost, time, and setup. Treat them as estimates until you confirm the file in your slicer.

2 model files

Typical selected file

31g

Based on 25% main infill for the largest likely-needed model file

Material cost

$0.75

Filament only at roughly $24/kg ABS / ASA

Print time

53m–1.5h

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	ABS / ASA 20%	ABS / ASA 25%	100% solid	Recommendation
Left_speaker_holder_Smart_453_-_Pioneer_TS-G1030F.stl	Choose left variant	1.1 MB STL	29g $0.69	31g $0.75	68g $1.64	Use ABS / ASA, 4 walls, 25% infill. Pick the matching side before printing.
Right_speaker_holder_Smart_453_-_Pioneer_TS-G1030F.stl	Choose right variant	1.1 MB STL	29g $0.69	31g $0.75	69g $1.64	Use ABS / ASA, 4 walls, 25% infill. Pick the matching side before printing.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Interior

Smart ForTwo 453 Rear Speaker Bracket

0 downloads33 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Rear speaker brackets for a Smart Fortwo 453 for Pioneer TS 1030F. Right side is incorrect and has to be rotated 10 degrees clockwise. But if you don't it still fits but is not aligned. Room between speaker and rear panel is 1 cm. I used foam tape at the edges of the bracket to get a flush seal between panel and speaker. Please use ABS for the temperatures that the car can reach. Nuts and washers for holding the bracket to the car M6, 6 times. Nuts, washers and bolt for holding the speaker to the bracket, M4, 8 times.