Spacer for MX-5 aftermarket side indicator repeaters. (Mk3 - NC) - image

Files (1)

IndiRing.stl

STL

5.4 MB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 95%	100% solid	Recommendation
IndiRing.stl	Primary model	5.4 MB STL	Slice file	Slice file	Slice file	Ensure a secure print bed adhesion to prevent warping

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Light Covers

Spacer for MX-5 aftermarket side indicator repeaters. (Mk3 - NC)

0 downloads35 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

I bought a pair of aftermarket side indicator repeaters for my MX-5 but was unhappy with the fit so designed a spacer to reduce improve the seating and look. I printed mine in PETG with shells and top/base values to make them nearly solid. Fitting instructions: 1) Put a smear of silicone sealant on each face and let it dry to improve grip and keep water out. 2) Remove existing repeaters by sliding in a credit card from the door side of the unit to release the clip and it will pull out. 3) Twist to remove the bulb holder and ensure it doesn't disappear into the car's wing. 4) Slip a printed spacer over the new repeater - Wide gap to the wider part of the repeater. 5) Insert the bulb holder into the repeater and clip it back into the car.