Subaru (12mm x 1.25) Shift Boot Retainer - image

Files (1)

Boot_retainer_2.STL

STL

1.1 MB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Boot_retainer_2.STL	Primary model	1.1 MB STL	Slice file	Slice file	Slice file	Ensure a strong bond between the retainer and the print bed to prevent warping.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Mechanical/Functional

Subaru (12mm x 1.25) Shift Boot Retainer

0 downloads37 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

If you are using a round shift knob, you're often stuck with an ugly gap where the shifter comes through the shift boot. This is a little adapter I made because the ones from Amazon are expensive and I'm too impatient for shipping. Installation: Depending on how the print turns out, you may be able to slide the retainer on, or you might have to thread it on. After installing the retainer, add in the jam nut and use the retainer like a wrench to tighten it down. Then when you get the shift knob screwed all the way down, loosen the retainer back up again -- holding the shift knob in place -- until the jam nut is wedged up against the shift knob. Done!