Subaru Forester 2019-2021 Cargo Cover Stopper - image

Files (5)

2022-12-25_tonneau_cover_stop_inner_v9.step

STEP

139.0 KB

bit.stl

STL

981.4 KB

bit_cover.stl

STL

547.4 KB

pin.stl

STL

75.4 KB

sleeve.stl

STL

1.0 MB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

5 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	TPU 20%	TPU 40%	100% solid	Recommendation
2022-12-25_tonneau_cover_stop_inner_v9.step	Cover / cap	139.0 KB STEP	Slice file	Slice file	Slice file	Use TPU; check sealing faces and verify in slicer.
bit.stl	Printable file	981.4 KB STL	Slice file	Slice file	Slice file	Ensure the piece that touches the interior is printed in TPU for sufficient friction
bit_cover.stl	Cover / cap	547.4 KB STL	Slice file	Slice file	Slice file	Use TPU; check sealing faces and verify in slicer.
pin.stl	Printable file	75.4 KB STL	Slice file	Slice file	Slice file	Ensure the piece that touches the interior is printed in TPU for sufficient friction
sleeve.stl	Printable file	1.0 MB STL	Slice file	Slice file	Slice file	Ensure the piece that touches the interior is printed in TPU for sufficient friction

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Trunk/Tailgate

Subaru Forester 2019-2021 Cargo Cover Stopper

0 downloads40 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Requires a 10mm diameter spring! (same as the original if you still have it) Subaru Part Name: *Stopper Tonneau Cover. (Right, Black)* Part Number: *65577AJ00BVH, 65577AJ00AVH* NOTE: The Subaru website lists this as a right-side part, but they are identical, and no left-side model is sold. The piece that touches the interior of the car should be printed in TPU if possible. PLA/PETG/ABS does not have enough friction to stay in place. Other parts can be printed in any filament, but recommend ABS for hot car reasons.