Supra rear foglight switch adapter - image

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

0 model files

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
No printable model files are available for an estimate yet.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Interior

Supra rear foglight switch adapter

0 downloads44 views0 likes

Download at source

Shared by

3DPrintedCarPart

Verified

Description

This is a fixture to place the Switch with the Audi number 8D0941563 in a Toyota Supra MK4 in the RHD version on the right hand Panel in the middle slot. The Front must be cut out of the panel and should be cut with care. I used a exactor knife and do the last 2 mm with a small file (takes a while, but looks pretty) The next project is to design a circuit for the switch to switch on/off the rear fog lights. This switch is a low power momentary switch.