Files (2)
Based on 25% main infill across listed model files
Filament only at roughly $24/kg PETG / ASA
Uses 70 mm/s, 0.2 mm layers; verify supports in slicer
| STL file | Role | Source size | PETG / ASA 20% | PETG / ASA 25% | 100% solid | Recommendation |
|---|---|---|---|---|---|---|
| Suzuki_Ignis_Base.stl | Printable file | 300.6 KB STL | 18g $0.42 | 19g $0.46 | 42g $1.00 | Ensure proper alignment of the key base and cup during printing |
| Suzuki_Ignis_Cap.stl | Cover / cap | 166.3 KB STL | 14g $0.34 | 16g $0.37 | 34g $0.82 | Use PETG / ASA; check sealing faces and verify in slicer. |
Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.
Suzuki Ignis key Base and Cup aligned
Shared by
3DPrintedCarPartDescription
It is a remake of key base to the clip section, the key cup dimensions correction, plus hole alignment. There are 2 hints about this model: 1. Don't forget to put inside, the immobilizer chip,in its specific section. In the original key you can access it, by removing the back cup. 2. There is some extra space, on right of key hole. It is needed to the let the key fit in. it should normally be filled with epoxy glue, after key fitting in the base. Have a nice day ( I hope you saved some money, as I did)!!
Compatible Cars
Originally published on thingiverse.com by Stee Mad (steeod) · License: CC BY
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Related Parts
Finding specific fitment/category matches first.
