Files (1)

tacoma_phone_mount.STL

STL

41.3 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 30%	100% solid	Recommendation
tacoma_phone_mount.STL	Mount / bracket	41.3 KB STL	Slice file	Slice file	Slice file	Ensure the phone mount is securely screwed into the Oh Sh*t handle

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Tacoma Phone Mount

0 downloads64 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

I wanted a phone holder for my 1997-2004 Tacoma that would allow me to stick on the magnet that came with my phone case: https://smile.amazon.com/gp/product/B08G8CTXBS I also wanted it to replace the screw for the Oh Sh*t handle on the driver side, so you can pop out the cover, unscrew the screw, and screw this back in. I'm not sure if the later ones have the same screw placement. I tested both a 30% infill and full infill, I think either of them will work. I have the 30% in my truck now. Of course, PETG or other heat-resistant filaments will work better for hot cars.