TESLA Model 3 - Easy To Print V4 - image

Files (5)

V4_Model_3_body.stl

STL

1.3 MB

V4_Model_3_raiserpads.stl

STL

156.3 KB

V4_Model_3_wheel.stl

STL

417.8 KB

V4_Model_3_4wheels.stl

STL

1.6 MB

V4_Model_3_body_-_w_mirrors.stl

STL

1.4 MB

Print guidance estimate

Uses saved filament metadata

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

5 model files

Recommended kit

50g

Based on 40% main infill across listed model files

Material cost

$1.20

Filament only at roughly $24/kg PETG / ASA

Print time

2.0h saved / 1.4h–2.4h estimate

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 40%	100% solid	Recommendation
V4_Model_3_body.stl	Printable file	1.3 MB STL	Slice file	Slice file	Slice file	Print the body with supports touching the buildplate for less deformation
V4_Model_3_raiserpads.stl	Printable file	156.3 KB STL	Slice file	Slice file	Slice file	Print the body with supports touching the buildplate for less deformation
V4_Model_3_wheel.stl	Printable file	417.8 KB STL	Slice file	Slice file	Slice file	Print the body with supports touching the buildplate for less deformation
V4_Model_3_4wheels.stl	Printable file	1.6 MB STL	Slice file	Slice file	Slice file	Print the body with supports touching the buildplate for less deformation
V4_Model_3_body_-_w_mirrors.stl	Printable file	1.4 MB STL	Slice file	Slice file	Slice file	Print the body with supports touching the buildplate for less deformation

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Accessories

TESLA Model 3 - Easy To Print V4

0 downloads162 views0 likes

Shared by

Michael Chen

Verified

Description

1 Piece body, print on the supports, less deformation from buildplate Print body with low infill, buildplate touching supports Wheels should be printed with higher infill and higher resolution (lower layer res and thinner line helps) Use 1.75mm filament as Axle, before assembling axle to the wheels add spacers. 2mm thick to the rear and 1.2mm to the front. Axle in the wheels should stay with force. If not, melt the end of filament or use super glue.