Files (5)

Model_Y_Rear_Cubby_1_piece.stl

STL

9.8 KB

Model_Y_Rear_Cubby_bottom.stl

STL

7.1 KB

Model_Y_Rear_Cubby_top.stl

STL

11.4 KB

Model_Y_Rear_Cubby.stl

STL

37.7 KB

Model_Y_Rear_Cubby_1_piece_with_inside_bits.stl

STL

34.7 KB

Print guidance estimate

Uses saved filament metadata

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

5 model files

Recommended kit

50g

Based on 25% main infill across listed model files

Material cost

$1.20

Filament only at roughly $24/kg PETG / ASA

Print time

2.0h saved / 1.4h–2.4h estimate

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Model_Y_Rear_Cubby_1_piece.stl	Accessory piece	9.8 KB STL	Slice file	Slice file	Slice file	Small functional file: print slowly; consider 80–100% infill for durability.
Model_Y_Rear_Cubby_bottom.stl	Accessory piece	7.1 KB STL	Slice file	Slice file	Slice file	Small functional file: print slowly; consider 80–100% infill for durability.
Model_Y_Rear_Cubby_top.stl	Accessory piece	11.4 KB STL	Slice file	Slice file	Slice file	Small functional file: print slowly; consider 80–100% infill for durability.
Model_Y_Rear_Cubby.stl	Printable file	37.7 KB STL	Slice file	Slice file	Slice file	For the 1-piece version, supports are likely needed, but check in your slicer.
Model_Y_Rear_Cubby_1_piece_with_inside_bits.stl	Printable file	34.7 KB STL	Slice file	Slice file	Slice file	For the 1-piece version, supports are likely needed, but check in your slicer.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Accessories

Tesla Model 3/Y rear cubby

0 downloads149 views0 likes

Shared by

Michael Chen

Verified

Description

The Model 3 and Model Y no longer come with the rear cubby container under the arm rest. I included some internal slots for a Samsung T5 SSD, coins, and card holders. Card wallets can be found here: https://www.thingiverse.com/thing:3020290 The 1 piece version will need to be printed with supports. Alternatively, you can print the bottom and top version (top is inverted) without supports, and glue them together. I haven't tested the fit myself, though. I also have the internal bits as a separate STL which you can import along with the regular cubby if you want to do multi-material, or do fuzzy edges on just the main cubby. You'll need supports if you're printing the 1 piece version. Otherwise, print the top and bottom versions, then glue them together.